My original email is below. Thanks to all that responded (there were many). The emails pointed out that if the 'diag-switch?' is set to true, the Netra T1 will boot from whatever 'diag-device' is set to (not what boot-device is set to). The emails said I had two options: 1. Set 'diag-switch?' to 'false' which would cause the T1 to boot from whatever is specified in 'boot-device'. 2. Set 'diag-device' to 'disk'. This is the route I took and it worked. -- Greg Mani SPAWAR Systems Center, Code D4223 Office: 619-553-4050 Lab 250B: 619-553-3938, ext 20 Lab 260: 619-553-5450 mani@spawar.navy.mil Greg Mani wrote: > I have a Netra T1 with solaris 8 installed on it. When I power on the > T1, it always trys to boot from net instead of the disk. If I type > 'boot disk' at the ok prompt, the T1 does boot from disk. > > If I do a 'printenv' from the ok prompt the 'boot-device' is equal to > 'disk'. > > If I boot the computer and do a 'eeprom' from the OS prompt, the > 'boot-device' is equal to 'disk'. > > Any suggestions on how I can get this computer to boot from disk when I > flip the power switch to on? > TIA for any help. > > -- > Greg Mani > SPAWAR Systems Center, Code D4223 > Office: 619-553-4050 > Lab 250B: 619-553-3938, ext 20 > Lab 260: 619-553-5450 > mani@spawar.navy.mil > > _______________________________________________ > sunmanagers mailing list > sunmanagers@sunmanagers.org > http://www.sunmanagers.org/mailman/listinfo/sunmanagers _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Fri Sep 28 09:57:38 2001
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:42:26 EST