Sorry for the delay in summarising, First thanks to the fellow admins: Hswe Barbra Ryan McEwan Edward Scown Gary Losito Malloy Jim and a special one for Tony Walsh whose quick responses and suggestions pointed me in the right way. The steps worked for me. 1. I have unplugged and plugged-in the serial cable back. 2. You have to be patient when you hit break key (ctrl + break in my case) and try it when system booting process started (not in LOM) until you get OK prompt. 3. Set the boot-device to disk. 4. Set the diag-device to disk. Have a good day > -----Original Message----- > From: SANTHAKUMAR Siva-Syntegra AU > Sent: Thursday, 27 September 2001 3:00 PM > To: 'sunmanagers@sunmanagers.org' > Subject: LOM - AC200 Netra > > > Fellow Admins, > > I have seen this before on this list but not the correct summary on this > yet. My problem is my AC200(brand new) is scrolling up with the message > "Time out waiting for ARP/RARP packet". I can not break in to change > anything. Tried .#, #. and poweron (I not getting lom> prompt). I am using > wyse terminal connected via LOM/serial a. > > Any help much appreciated. I will summarise. > > Thanks > > > <<Siva S Santhakumar (Santha).vcf>> _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Wed Oct 3 18:00:25 2001
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:42:26 EST