Summary: Pushing 100 full duplex

Thanks for all the responce on this one. 

The Lance Ethernet interface (le0) isn't capable of
100Mbit operation.
It's a 10M/sec-only port developed well before 100M
came along.
Its time for hme!!!

--- Justin Pippin <igrep4fun@yahoo.com> wrote:
> I am trying to push my sparc10 to 100 full and I
> keep
> getting the same error messages.
> I do not use hme* but le0
> 
> # ifconfig -a
> lo0:
> flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4>
> mtu 8232 index 1
>         inet 127.0.0.1 netmask ff000000 
> le0:
> flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4>
> mtu
> 1500 index 2
>         inet 192.168.1.10 netmask ffffff00 broadcast
> 192.168.1.255
>         ether 8:0:20:1a:fd:2e
> 
> 
> I try 
> 
> # ndd -set /dev/le0 instance 0
> couldn't push module 'le0', No such device or
> address
> 
> and I replace le0 with everything under the sun "no
> pun intended" but it does not work.
> 
> Please help 
> 
> Thanks,
> Justin
> 
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute
> with Yahoo! Messenger
> http://phonecard.yahoo.com/
> _______________________________________________
> sunmanagers mailing list
> sunmanagers@sunmanagers.org
>
http://www.sunmanagers.org/mailman/listinfo/sunmanagers


__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/