SUMMARY: controlling ADIC scalar 100 from command line

From: Doug Floer <dfloer_at_topsoft.ca>
Date: Sat Mar 02 2002 - 00:28:36 EST
two great suggestions from Toby Rider (robtest from veritas) and Steve
Sandau (mtx).  mtx get the nod cause it's free!  thx!!


ORIGINAL MESSAGE BELOW:

any of you folks know how to control an ADIC Scalar 100 tape array from the
command-line?  say, using mt or whatever.  from networker?  ie, how to
load/empty a specific tape slot, etc.

thanks,
doug
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
Received on Fri Mar 1 23:30:09 2002

This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:42:35 EST