[ Original question below ] The suggestions where 'what is local-mac-address set to?'. It was set to true by default. This is the first Sun machine I see on which this setting was true by default. I switched it to false and I could boot through the qfe0 interface. Strange thing however: when the setting was true, all test commands resulted in that was no connectivity on the interface (which was absolutely not true) and sometimes I got 'Out of memory'. Thanks to: Joon H Philip M Grisedale J. Oquendo Angelo Lamera Bertrand Hutin Darren Dunham Remy Zandwijk > I have an new V240 in which I installed a Quad Fast Ethernet interface > (tried both PCI 0 and PCI 1). When doing: > > boot /pci@1d,700000/pci@1/SUNW,qfe@0,1 > > in the boot prom, it says: > > Timeout waiting for ARP/RARP packet > > > The link light on the ethernet port is on and when trying the same > UTP cable on the bge0 interface, it just boots like a charm. The > cable is attached to a Cisco 3548 switch and I tried all the obvious > settings (100/full, 10/half, auto/auto. Fast port is enabled). > > Why does the V240 not boot from the qfe interface? _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Sun Feb 8 11:48:24 2004
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:29 EST