Thank you to all who responded. I did not have a chance to "try" all recommendations. Here was the solution. This was supplied by Richard Rimbach. Thank you Richard! Here's a quick note I have on Leadville Stack That Leadville stack note. No sd.conf or lpfc.conf to worry about.. 1. Zone HBAs-SPs 2. Add Host to Storage Group 3. Run devfsadm -v (may not be necessary) 4. Run cfgadm -al will list the Controller numbers being used, looks like: c1: c2: 5006061100345f unconfigured unknown c3: 500606A100345f unconfigured unknown c4: 5. Run cfgadm -c configure c2 c3 will scan and configure devices on the contollers 6. Run powercf -q; powermt config; powermt display....Done Deal.. Michael Warnock UTS/x38031 CONFIDENTIALITY STATEMENT. The information contained in this e-mail message, including attachments, is the confidential information of, and/or is the property of, Vanguard. The information is intended for use solely by the individual or entity named in the message. If you are not an intended recipient or you received this in error, then any review, printing, copying, or distribution of any such information is prohibited, and please notify the sender immediately by reply e-mail and then delete this e-mail from your system. _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Fri Mar 10 09:50:36 2006
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:56 EST