Original Question: I have a V490 running Solaris 9, Veritas 3.5, EMC PowerPath 4.5 connected to an EMC SAN using 2 Emulex LP9802 HBA's. We're going to switch the HBA's to 2 QLogic 2340's. I use the PowerPath pseudo devices created by powervxvm in VxVM. I've used vxdiskadm to prevent the multipath devices from VxVM's view. Are there any gotcha's I should know about? How easy will this be to do? Summary: There were no problems with the switch. I installed the latest StorEdge Foundation Suite software and took the system down to swap out the cards. Upon reconfigure reboot (after the SAN guys changed the config to present to the new WWNs), I just had to run cfgadm to configure the controllers (cfgadm -c configure c#), I also ran "devfsadm -Cv", and then "powercf -q". That was it. Veritas was able to see the LUNs. Thanks To: Joe Fletcher Lou Germain Bob Metcalf Charles Mengel _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Tue Sep 26 08:59:05 2006
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:44:01 EST