-YOu can try a "Stop-N" to restore factory NVRAM defaults. Otherwise try minimising the diags and booting a FW update -image. -- -joe_fletcher I tried it but nothing happend, there is a password on admin in ALOM. I tried to move battery from MB and from ALOM card( without power cable of course) and left if on 6 hourse with the same result.There is still password on admin(I try serial nuber of card first 8 digit and the last and wtihout password too) Al I can do is push Esc and see "ALOM <ESC> Menu f - Wait for flash download from host. C - Copy Boot Monitor from FLASHBOAT. j - Jump to main code (at 0x01010000). m - Run POST Menu. (Do not try this after a flash update of the boot monitor!) d - play DOOM s - Set clock speed e - Set external and internal console serial ports baud rate i - Set internal control serial port baud rate t - Toggle 'OK' flag R - Reset SC b,h,w - Read byte/halfword/word B,H,W - Write byte/halfword/word r - Return to bootmon Your selection: r ALOM POST 1.0 Status = 00007fff" I tried all letters and the password still exist for ALOM console -My answer would be: Replace the battery and find correct SCC card for the -system. -System refuses to power on if SCC card is not valid or is missing. -- -Jussi Sallinen I realised that I haven't SCC at all. It is no in SCC reader. Can I start the server and install Solaris without System config card? -Looks like RSC card ( which has the battery to get the console even if the power is not given to the system) has gone -bad, see if you can bet is replaced. -- -"Bhaskar G" I have access to console but have no password for them and I still can't reset this pass. nOWYE kARTY@Mail.Ru S PROBKAMI I SPUTNIKAMI! http://r.mail.ru/cln4831/map.mail.ru/ _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Wed Jun 3 02:10:34 2009
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:44:14 EST