Thank you to: gurudatta nadig DRoss-Smith DUCARROZ Birgit joe fletche Chris Ruhnke Most of their suggestions had been done. I did a re-configure on the disks for RAID 5 from the RAID controller page. I then re-initialize the virtual disk group. Rebooted the server and the disk was recognised from "format". "newfs" and "fsck" the new disk and the disk was mounted ready to be used. Regards Alan On 12/3/2009 12:26 PM, Alan Kong wrote: > Dear Managers, > > I need to your help to add disk to my system. > > I have a Dell T710 which has 8 x 1 TB SATA hard disks. > > At initial install of Solaris 10 x86 (10/09), 2 hard disks were > configured mirror using the on-board RAID controller. The root file > system used ZFS. There was no problem with the installation. Now I > intended to use the rest of the hard disks. The rest of the 6 hard > disks were config RAID 5 using the on-board RAID controller. However the > disk was not recognised/detected with the following commands: format, > devfsadm, cfgadm -al. > > I have Googled. The disk could be added by: > 1) devfsadm -vC > 2) format > 3) newfs > > The procedure just did not work on my computer. > > Thank you. > > Regards > Alan > _______________________________________________ > sunmanagers mailing list > sunmanagers@sunmanagers.org > http://www.sunmanagers.org/mailman/listinfo/sunmanagers _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Fri Dec 4 02:59:46 2009
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:44:15 EST