SUMMARY: Procedure to replace failed qlogic hba on Sun Cluster 3.1 node

Thanks to Dean Ross-Smith, Rajendra Singh,  Nick Hindley, Jonathan Adams
for their replies.

I replaced the hba and peformed a boot -rx on the single node, booted up into
cluster and failed resources back over.  No issues.

Tom Jones

----- Original Message ----- 
From: "Tom Jones" <tjones@statesman.com>
To: "Sun Managers List" <sunmanagers@sunmanagers.org>
Sent: Sunday, June 27, 2010 11:22 AM
Subject: Procedure to replace failed qlogic hba on Sun Cluster 3.1 node


> I have to replace a failed 2GB dual port Qlogic HBA on
> a Sun V1280 running Solaris 9 with Sun Cluster 3.1,
> dual connected to two StorEdge 3510FC arrays.
> 
> The Sun Cluster 3.0-3.1 With Sun StorEdge 3510 procedure
> appears to be too simple: scswitch to other node,
> power down, replace hba, power up/boot into cluster,
> scswitch back.
> 
> I'm concerned about quorum device that is on this
> array and any other issues with WWN, device mappings, etc.
> 
> Looking for recommendations, past experiences, procedures.
> 
> Thanks
> Tom Jones
> Austin American-Statesman
> _______________________________________________
> sunmanagers mailing list
> sunmanagers@sunmanagers.org
> http://www.sunmanagers.org/mailman/listinfo/sunmanagers
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers