Hi all,
My original question was:
>I would like to add a 5th scsi disk to an SS2 but the GENERIC config file
>only accomidates 4 by default. Has anyone added a 5th disk to their work-
>station? The config file is as follows:
Thanks for the responses from:
lidl@eng.umd.edu (Kurt J. Lidl)
nicky@davinci.concordia.ca
valdes@geosun.uchicago.edu
pomeranz@isis.dccs.upenn.edu (Hal Pomeranz)
etnibsd!vsh@uunet.UU.NET (Steve Harris)
ronnoco!miker@oddjob.uchicago.edu
synergy!sun!fourx.Aus!kevin@Sun.COM
eap@bu-it.bu.edu (Eric A. Pearce)
markw@utig.ig.utexas.edu
And thanks to the responses I'll get after this summary!
All said it can be done.
I tried it and it seems to work. I changed the following line in config file
from:
tape st1 at scsibus0 target 5 lun 0 # second SCSI tape
to:
disk sd4 at scsibus0 target 5 lun 0 # fifth hard SCSI disk
and used target id 5 on the disk.
I get erros while it is booting up but not while it is up.
The erros I get are :
vmunix: esp0: Target 3 now Synchronous at 4.0 mb/s max transmit rate
vmunix: esp0: Target 1 now Synchronous at 4.0 mb/s max transmit rate
vmunix: esp0: Target 2 now Synchronous at 3.334 mb/s max transmit rate
vmunix: esp0: Target 0 now Synchronous at 3.334 mb/s max transmit rate
vmunix: esp0: Target 5 now Synchronous at 4.0 mb/s max transmit rate
vmunix: esp0: Current command timeout for Target 3 Lun 0
vmunix: sd0: SCSI transport failed: reason 'reset': trying command
Does anybody why the timeout?
Thanks again!
Joe Ledva
jledva@astro.dnet.ge.com
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:06:21 CDT