Hi,
I asked:
> How do I set the PROM password on a Sparc 10? The ROM rev is 2.9.
>
> I have tried setenv security-password but cannot get it to work. Do I also
>need to use setenv security-mode? What is the correct format of these
>commands?
The answer is document in the eeprom(8S) man page.
To setup the PROM so that the only commands available at the monitor prompt
are BOOT and CONTINUE, use:
eeprom security-mode=command
You are prompted for a password which is then used to control access to
other EEPROM commands.
Thanks to:
bill@hobbes.access.com (It's easy to RTFM when you know the command you're
looking for! ;-)
Dave.
--------------------------------------------------------------------------
JANET : D.Haywood@uk.ac.sheffield-hallam | Dave Haywood.
or D.Haywood@uk.ac.shu | Computer Services,
INTERNET: D.Haywood@shu.ac.uk | Sheffield Hallam University
Telex : 54680 SHPOLY G | Pond Street,
Tel : +44 742-533-828 | Sheffield. S1 1WB. ENGLAND.
FAX : +44 742-533-840 |
X.400:/I=D/S=Haywood/O=Sheffield-Hallam/PRMD=UK.AC/ADMD= /C=GB
X.500:@c=GB@o=Sheffield Hallam University@ou=Computer Services@cn=Dave Haywood
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:08:05 CDT