Original message:
>
> The following is the /var/adm/messages that we got after we booted
up
> from a backup harddrive. My question is: Is the SCSI bus alright or
> just the FUJITSU hard drive.
> Thanks.
>
> Mar 9 23:04:39 kronecker vmunix: esp0: SCSI bus DATA IN phase
parity
> error
> Mar 9 23:05:19 kronecker vmunix: esp0: SCSI bus DATA IN phase
parity
> error
> Mar 9 23:05:19 kronecker vmunix: esp0: Disconnected command timeout
> for Target 1 Lun 0
> Mar 9 23:05:19 kronecker vmunix: sd0: SCSI transport failed:
> reason 'reset': retrying command
> Mar 9 23:05:19 kronecker vmunix: sd1: SCSI transport failed:
> reason 'timeout': retrying command
> Mar 9 23:05:19 kronecker vmunix: sd0: SCSI transport failed:
> reason 'unexpected_bus_free': retrying command
> Mar 9 23:05:19 kronecker vmunix: esp0: Target 3 rejects our message
> '<unknown msg 0xff>'
The Fujitsu 2gig hard drive definitely got burned. It was possibly
due to one of the users power cycled the drive on the SCSI chain while
the system was up. We're shipping it back to Megahause to get
repaired. However, our 64Mb memory board on one of the three sbus
slots of a sparc 2 also got burned, as are two sbus slots. It was not
just a hard drive but more expensive sbus slots that really hurt. We
are going to secure all our equipment physically.
Thanks
-- Thomas Wong We don't eat pork tom@gursey.baruch.cuny.edu But we like raw snake meat Voice: 212-447-3047 We are the piglets family Fax: 212-447-3076 ---The Piglets
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:08:57 CDT