Dear Managers:
THE QUESTION:
I am trying to install a 9 Gb External Seagate BARRACUDA in a
SS10, which is not recgnizing that disk. Following the manufac
turer instructions, this disk works properly with any SCSI-I,
SCSI-II and Ultra_SCSI controllers.
I have Solaris 2.4 in the machine, and the disk is phisically
properly installed, I mean, it is terminated, as suggested by
its instructions.
Is there any step to be followed in a way to have it working?
THE SOLUTION:
The BARRACUDA comes pre-adjusted to the target SCSI number 4
or 2, which are used by the SS10 prom to tapes. So just change
the physical target scsi, in the disk to 0 (zero).
After doing so, reboot the machine with the -r parameter:
>boot -r
THANKS TO:
Rick Reineman (home)" <reineman1@raiders.llnl.gov>
plw@ncgr.org (Peter L. Wargo)
Dino Rivera <dinor@corsair.com>
"Eichele, Derek" <Derek_Eichele@AIMFUNDS.COM>
jim@telecnnct.com
Ronald Loftin <reloftin@mailbox.syr.edu>
----------------------------------------------------------------------------
Renan Martins Baptista PETROBRAS Research & Devlopment Centre
Senior Petroleum Engineer Cidade Universitaria, qd 07 DIPLOT
Phone: (+55 21) 598-6556/6935 Ilha do Fundao, Rio de Janeiro,
Fax : (+55 21) 598-6796/6795 RJ, BRAZIL - 21949-900
E-mail: renan@cenpes.petrobras.com.br
____________________________________________________________________________
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:12:33 CDT