My Original Message:
A predecessor connected our Sparc20 to a console switcher and in order to
allow it to display on a VGA monitor, he made some eeprom changes. What
changes I dont know. I have read the FAQ and tried some of its suggestions.
I have read the man page on eeprom. What I'm looking for is a way to
reset
the eeprom settings back to the original factory configuration.
Currently I have the system on a Raritan switcher and cannot see the
console. I have to connect in via the net to access the system. I could
connect a dumb terminal to the serial port but that isnt the solution I'm
looking for. BTW: I'm running SunOS 414. TIA.
------------------------------------
Thanks to:
From: Barry Gamblin <bgamblin@hao.ucar.edu>
From: Mike Watts <mikewatts@traverse.com>
From: Michael Stapleton <michaels@learnix.com>
From: Terry Gardner <gardnert@netcom.com>
From: "Salehi, Michael E" <Mike.Salehi@usa.xerox.com>
From: "Reichert, Alan" <aareichert@tasc.com>
From: "Balfour, Scott (Eurosoft)" <scott.balfour-eds@eds.com>
From: "Palmieri, Matt" <Matt.Palmieri@cmsis.com>
From: Adrian Stovall <adrians@solarsystems.com>
And everyone who will respond after I send this :-)
------------------------------------
The answers:
set-defaults at the OK prompt.
if you plug all the regular sun keyboard in and press ALT-N on power up you
get factory default.
turn off machine
connect a sun keyboard to the machine
hold down stop and n when you power on
this will reset it to factory defaults
------------------------------------
IMHO this is a good candidate for the FAQ.
-- -=( Paul Wood http://pobox.com/~paul.wood)=- -=( paul.wood@pobox.com Temple University Network Services)=-
This archive was generated by hypermail 2.1.2 : Fri Sep 28 2001 - 23:13:34 CDT